Introduction Configuring ACL
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
6-46
DESTROY ACCESSLIST
Syntax
DESTROY ACCESSLIST={ accesslistname-list | ALL } [ FORCE ]
Description Attempts to remove every specified ACCESSLIST from the system, and returns an error
message for any that cannot be destroyed. By default this command is allowed only if no
interfaces are currently associated with the ACCESSLIST(s).
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
.
Example DESTROY ACCESSLIST=metro
Option Description Default Value
ACCESSLIST The ACCESSLIST Name that already exists.
FORCE Using the FORCE option will override this behavior and
remove ACCESSLIST(s) from the interfaces before
destroying them. Otherwise, use DELETE ACCESSLIST
to delete the interface associations.
To Next Page
Loading...
