Introduction Configuring Port Authentication
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
6-124
SHOW AUTHENTICATION COUNTER
Syntax
SHOW AUTHENTICATION COUNTER [INTERFACE={type:id-range|id-range|
ifname-list|ALL}] [SUPPLICANT=macaddress-list|ALL]
[TYPE={STATISTICS|DIAGNOSTICS|SESSIONSTATISTICS|ALL}] [FULL]
Description Displays the counters/statistics of the supplicants.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
SHOW AUTHENTICATION COUNTER
--- Port Authentication Statistics Counters ---
ETH:6.22 : 00:09:41:58:E6:F2
---------------------------
EAPOL Rx Tx Start Logoff Invalid
2 19 0 0 0
EAP Resp/Id Response Req/Id Tx Req Tx LenErr
0 2 0 19 0
--- Port Authentication Diagnostics Counters ---
ETH:6.22 : 00:09:41:58:E6:F2
---------------------------
Option Description Default Value
INTERFACE The ethernet interfaces over which the Counters will be
shown.
ALL
SUPPLI-
CANT
Specifies a supplicant's MAC address or ALL supplicants. ALL
TYPE The type of counters/statistics
STATISTICS -
DIAGNOSTICS -
SESSIONSTATISTICS -
ALL
ALL
FULL Display more descriptive information Abbreviated
To Next Page
Loading...
