Allied Telesis SwitchBlade x3100 Series - Page 774

Introduction Configuring DHCP Relay
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
7-36
ENABLE DHCPRELAY INTERFACE
Syntax
ENABLE DHCPRELAY={ dhcpname-list | MAIN | ALL } INTERFACE={
type:id-range | id-range | ifname-list | ALL }
Description The command ENABLE DHCPRELAY enables the DHCP relay function on the specified
interfaces. Ensure that DHCPRELAY is enabled on the Network-side interfaces.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
ENABLE DHCPRELAY=x3112 INTERFACE=ALL
Option Description Default Value
DHCPRELAY The name of the DHCP instance
dhcpname-list - list of specific DHCP instances
MAIN - the default DHCP instance
ALL - all DHCP instances
N/A
INTERFACE A logical representation of one or more physical ports;
the INTERFACE to enable DHCP Relay service on.
type:id-range - the type of available ports, such as ETH
or LAG
id-range - used with type (type:id) to query the physical
ports; the numerical identifier of the interface
ifname-list - list of interface names, if not numerical
ALL - all interfaces in the system
N/A