Introduction Configuring DHCP Relay
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
7-38
RESET DHCPRELAY COUNTER INTERFACE
Syntax
RESET DHCPRELAY COUNTER INTERFACE={type:id-range|id-range|ifname-
list|ALL}
Description This command resets the DHCP Relay packet counts on the specified interface. If 'all'
interfaces are specified, all individual interface DHCP Relay counters are reset.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
RESET DHCPRELAY COUNTER INTERFACE=ALL
Option Description Default Value
INTERFACE The interfaces where the counters are reset.
To Next Page
Loading...
