Configuring BFD Introduction
7-131
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
SET BFD INTERFACE
Syntax
SET BFD INTERFACE={ type:id-range | id-range | ifname-list | ALL }
[ INTERVAL=1..60000 ] [ DETECTIONMULTIPLIER=2..255 ]
Description Changes the default values for the interface.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
SET BFD INTERFACE=8.18,8.19 DETECTIONMULTIPLIER=30
Option Description Default Value
INTERFACE The interface where the BFD values will be modified.
INTERVAL Specifies the desired interval in milliseconds between
transmitted packets
200ms
DETEC-
TIONMULTI-
PLIER
The number of consecutive missed packets required to
declare a failure.
3
To Next Page
Loading...
