Allied Telesis SwitchBlade x3100 Series - Page 881

Configurable Alarm Severity (Interface Alarm) Introduction
8-9
Software Reference for SwitchBlade x3100 Series Switches (Alarms and Troubleshooting)
SET INTERFACE ALARM SEVERITY
Syntax
SET INTERFACE={ type:id-range | id-range | ifname-list | ALL }
ALARM SEVERITY={ NONE | INFO | MINOR | MAJOR | CRITICAL }
[ FORCE ]
Description Changes the alarm severity for the interfaces specified.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
SET INTERFACE 0.23 ALARM SEVERITY=MAJOR
Info (020186): Successfully modified interface(s) ETH:[0.23]
Option Description Default Value
INTERFACE The interface(s) that will have their alarm severity set.
ALARM
SEVERITY
The alarm severity to apply to alarms generated by the
specified interfaces.
N/A
FORCE Disables the confirmation message.