Introduction Configurable Alarm Severity (Interface Alarm)
Software Reference for SwitchBlade x3100 Series Switches (Alarms and Troubleshooting)
8-10
SETDEFAULTS INTERFACE ALARM
Syntax
SETDEFAULTS INTERFACE={ type:id-range | id-range | ifname-list |
ALL } ALARM [ SEVERITY ]
Description For the Interfaces specified, set the alarms (back) to the default level.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
SETDEFAULTS INTERFACE ALL ALARM
Info (020186): Successfully modified interface(s) ETH:[0-3,6-9.0-23],[10-11.0-
3]/VLAN:[10.0]
Option Description Default Value
INTERFACE The interfaces that will have their alarm severities set to
the default.
SEVERITY The alarm severity to apply to alarms generated by the
specified interfaces
To Next Page
Loading...
Need help?
General
