Allied Telesis SwitchBlade x3100 Series - Page 886

Introduction Configurable Alarm Severity (Interface Alarm)
Software Reference for SwitchBlade x3100 Series Switches (Alarms and Troubleshooting)
8-14
SHOW INTERFACE ALARM SEVERITY
Syntax
SHOW INTERFACE [ ={ type:id-range | id-range | ifname-list | ALL }
] ALARM SEVERITY [ ={ NONE | INFO | MINOR | MAJOR | CRITICAL |
DEFAULT | NONDEFAULT | ALL } ]
Description Lists the interfaces and the alarm severities that are associated with them. If the severity
is the default level, '(Default)' is shown next to the interface. These levels may be
changed because of the
SET INTERFACE ALARM SEVERITY command.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
SHOW INTERFACE 0.23 ALARM SEVERITY=MAJOR
--- Interface Alarms Settings ---
Interface Severity
------------ --------
0.23 Major (default)
Option Description Default Value
INTERFACE The interfaces that will have their alarm severities dis-
played.
ALARM
SEVERITY
The alarm severity to display:
NONE
INFO
MINOR
MAJOR
CRITICAL
DEFAULT
NONDEFAULT
ALL
ALL