Introduction Configuring the Management Interfaces
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
1-68
SET IP INTERFACE
Syntax
SET IP INTERFACE={ MGMT | type:id-range | ifname-list | ALL } [
IPADDRESS=ipaddress ] [ SUBNETMASK=mask ] [ IFNAME=ifname ] [ MAN-
AGEMENT={ YES | NO } ]
Note: The SBx3112 only supports a single default gateway, DNS server, and Domain Name, and so these
parameters do not appear on the SET IP INTERFACE and ADD IP INTERFACE commands.
Description Changes the existing setting for the MGMT or VLAN interface. If this command is exe-
cuted while the interface is in use, users of the interface must reconnect after the set-
tings are applied by the system.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example SET IP INTERFACE=MGMT IPADDRESS=10.52.70.36
SUBNETMASK=255.255.255.0 MANAGEMENT=YES
Option Description Default Value
INTERFACE The data packet interface for the system.
MGMT - for the dedicated interface
type:id - for the inband, the VLAN to be used
ifname-list - The names for the interfaces if they exist
ALL - All of the IP interfaces
N/A
IPADDRESS The IP address of the system N/A
SUBNET-
MASK
The subnet mask to associate with the given interface. N/A
IFNAME A name that can be given for the interface. N/A
MANAGE-
MENT
Allows MANAGEMENT access to this interface.
YES - The interface can be used for MANAGEMENT. A
user can Telnet directly into a MANAGEMENT interface
and use it for remote access.
NO - The interface cannot be used for MANAGEMENT.
YES
To Next Page
Loading...
