Using loopback Commands 341
Verifying Loopback Mode 342
Using the Cisco IOS Event Tracer to Troubleshoot Problems 343
Preparing for Online Insertion and Removal of a SPA 343
CHAPTER 21
Overview of the Cisco WebEx Node for the Cisco ASR 1000 Series Routers 345
Release History 345
Overview of the Cisco WebEx Node SPA Environment 346
Cisco WebEx Node Management System 347
Supported Features 348
Restrictions 349
Supported MIBs 350
Displaying the SPA Hardware Type 350
Example of the show interfaces service-engine Command 351
Example of the show hw-module subslot service-engine status Command 351
CHAPTER 22
Configuring the Cisco WebEx Node for the ASR 1000 Series Aggregation Services
Routers 353
Prerequisites 353
Registering with the WebEx Data Center and the Cisco WebEx Node Management
System 353
Obtaining an Account in the Cisco WebEx Node Management System 354
Registering a Cisco WebEx Node SPA in the Cisco WebEx Node Management
System 355
Completing the Cisco WebEx Node SPA Configuration Prerequisites 356
Configuration Tasks 357
Specifying the Service Engine Interface Address on the Cisco WebEx Node SPA 357
Configuring the Virtual Service Engine Interface 358
Virtual Service-Engine Interface Configuration Guidelines 358
What To Do Next 361
Saving the Configuration 361
Shutting Down and Removing the Cisco WebEx Node SPA 361
Verifying the Service Engine Configuration 362
Showing Cisco WebEx Node SPA Settings and Activity 362
Showing Service Engine Status 363
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
xviii OL-14127-17
Contents
To Next Page
Loading...
Need help?
General
