CDM-570/570L Satellite Modem with Optional IP Module Revision 12
Table of Contents MN/CDM570L.IOM
v
CHAPTER 3. REAR PANEL CONNECTORS AND PINOUTS ............................................. 3–1
3.1 Connector Overview ................................................................................................................... 3–1
3.2 IF Connections ............................................................................................................................ 3–3
3.2.1 Rx IF Connectors .................................................................................................................. 3–3
3.2.2 Tx IF Connectors .................................................................................................................. 3–3
3.3 IF Connections ............................................................................................................................ 3–4
3.3.1 Data Interface Connector, DB-25F ....................................................................................... 3–4
3.3.2 G.703 Connections ................................................................................................................ 3–5
3.3.2.1 G.703 Balanced E1/T1 Interface Connector, DB-15F................................................................... 3–5
3.3.2.2 G.703 E1/T1 RJ-48 Connection via G.703 Balanced Interface Connector ................................. 3–6
3.3.2.3 G.703 Unbalanced Interface Connectors (Tx/Rx), 75Ω BNC ...................................................... 3–6
3.3.3 10/100 BaseT Ethernet Connections ..................................................................................... 3–7
3.3.3.1 10/100 BaseT Ethernet Management (M&C) Port, RJ-45 (Standard) ......................................... 3–7
3.3.3.2 10/100 BaseT Ethernet Traffic Port, RJ-45 (with Optional IP Module only) .............................. 3–7
3.4 Utility Connections ...................................................................................................................... 3–8
3.4.1 Remote Control Interface Connector, DB-9M ...................................................................... 3–8
3.4.2 Form-C Traffic Alarms Connector, DB-15M ....................................................................... 3–8
3.4.3 1:1 Control Interface Connector, DB-9F .............................................................................. 3–9
3.4.4 Ext Ref Connector, BNC .................................................................................................... 3–10
3.4.5 Async- Serial Console, RJ-11 (with Optional IP Module only) ......................................... 3–10
3.5 Power and Ground Connections .............................................................................................. 3–11
3.5.1 Alternating Current (AC) Power Connector (Standard) ..................................................... 3–11
3.5.2 Optional Direct Current (DC) Power Connector
................................................................ 3–11
3.5.2.1 24 V or 48V DC Units – CDM-570 or CDM-570L Units .......................................................... 3–11
3.5.2.2 48 V DC Units – CDMR-570L Unit Only ................................................................................... 3–12
3.5.3 Ground Connector ............................................................................................................... 3–12
CHAPTER 4. UPDATING FIRMWARE ................................................................................. 4–1
4.1 Updating Firmware via Internet ............................................................................................... 4–1
4.2 About Firmware Files, Naming, Versions and Formats .......................................................... 4–1
4.3 Preparation for the Base Modem Ethernet FTP Upload Procedure ...................................... 4–3
4.4 Base Modem Bulk Firmware Update – Ethernet FTP Upload Procedure ............................ 4–4
4.5 Ethernet IP Module FTP Upload Procedure ............................................................................ 4–6
4.6 USB Procedure ............................................................................................................................ 4–9
CHAPTER 5. FRONT PANEL OPERATION ......................................................................... 5–1
5.1 Introduction ................................................................................................................................. 5–1
To Next Page
Loading...
