CDM-570/570L Satellite Modem with Optional IP Module Revision 12
Ethernet-based Remote Product Management MN/CDM570L.IOM
6–3
HTTP Login User Access Levels are further defined as follows:
Admin User Read/Write User Read Only User
Full Access to all web
pages
No Access to Admin pages No Access to Admin pages
Full Access for all other web pages View Only Access for all other web pages
If login is attempted and remote control is set to either Local or Remote mode,
access is prohibited and the following error message displays in the browser
window:
To properly access the CDM-570/570L HTTP Interface, configure remote control access for the
unit to Ethernet mode. From the CDM-570/570L front panel, use the ◄ ► and
▲▼ arrow
keys to first navigate to the remote control configuration menu, and then select Ethernet mode
(press ENTER when done):
SELECT: CONFIG Æ Rem Æ Ethernet
6.3.1.2 Navigation
This manual uses a naming format for all web pages to indicate the depth of navigation needed to
view the referenced page: “Top Level Tab | Page Hyperlink”
For example: “Home | Support” is interpreted to mean “first click the top-level ‘Home’
navigation tab; then, click the ‘Support’ page hyperlink.
Roll the cursor over the navigation tabs located at the top of each
page, and then select from the available page hyperlink. You can
fully monitor and control base operations of the CDM-570/570L
from the HTTP Interface. Roll the cursor over the navigation tabs
located at the top of each page (shown at right) to select from the
available nested hyperlinks.
See the pertinent chapter or section in this manual, as previously listed, for detailed information
on navigating the specific CDM-570/570L HTTP Interface.
6.3.1.3 Page Sections
Each web page is divided into operational content sections.
Whether there is one section to a page, or there are multiple
To Next Page
Loading...
