Comtech EF Data CDM-570 - Maint | Save; Figure 13-36. Maint | Save Page

CDM-570/570L Satellite Modem with Optional IP Module Revision 12
Ethernet IP Module Interface MN/CDM570L.IOM
13–63
13.6.2.6.3 Maint | Save
Figure 13-36. Maint | Save page
This page appears once the Save hyperlink is selected. If running IP Module V1/MPP-50
Firmware Version 1.5.3.2 or later, all configuration changes made via the IP Module HTTP
Interface are automatically saved to Flash memory until either a new round of settings updates is
initiated, or all settings are restored to the original factory defaults using the ‘Maint |
Operations’ page.
Press [Backspace] on the keyboard as prompted by this page, or select any one of the HTTP
Interface navigation tabs/hyperlinks, to return to the previously active HTTP Interface page or to
select other modem functions.
When the Workin
g
Mode is set to Vipersat, Base Modem and IP Module
m
odifications are not automaticall
y
saved and will be lost if the unit is rebooted.
A
dditionall
y
, if the Workin
g
Mode is set to Vipersat the unit ma
y
also load the
Vipersat Homestate confi
g
uration upon reboot.
For specific information abo
u
t CDM-570/570L IP Module operation when
deplo
y
ed in a Vipersat s
y
stem, see ad
j
unct Comtech EF Data publication
MN/22125 – Vipersat CDM-570/570L Satellite Network Modem Router User Guide.