CDM-570/570L Satellite Modem with Optional IP Module Revision 12
Appendix K MN/CDM570L.IOM
K–25
• Gain Offset (1:1 Redundancy Only): Select the desired setting from the drop-down menu
• Amplifier: Select On or Off from the drop-down menu
Down Converter Parameters
• Frequency: Enter a value in MHz
• Attenuation: Enter a value in dB
• Slope Mode: Select Manual or Calibrated from the drop-down menu
• Slope Adjust (Manual Mode Only): Select the desired setting from the drop-down menu
• Mute: Select Enabled or Disabled from the drop-down menu
• Gain Offset (1:1 Redundancy Only): Select the desired setting from the drop-down menu
Unit Parameters
• Mute Mode: Select Muted after freq change or Unmuted after freq change from the
drop-down menu
• Auto Fault Recovery or Cold Start: Select Enabled or Disabled from the drop-down
menus
• Ext Reference Fault Logic: Select Summary or No Summary from the drop-down menu
• Reference Oscillator Adjust: Enter a value from 0 to 255
LNA Parameters
• Current Alarm Window: Enter a value of 20 to 50, or 99 to disable this feature
• Current Source: Select Enabled or Disabled from the drop-down menu
• Fault Logic: Select Summary or No Summary from the drop-down menu
ODU Circuit Identification
Enter an ODU Circuit Identification name of up to 24 alphanumeric characters.
Click [Submit] to save any changes made to this page.
To Next Page
Loading...
