CDM-570/570L Satellite Modem with Optional IP Module Revision 12
Ethernet-based Remote Product Management MN/CDM570L.IOM
6–8
Whenever modifying the Modulator or Demodulator parameters by SNMP, it is
important that the variables must be executed in the following:
1. FEC (Forward Error Correction)
2.
Modulation or Demodulation
3.
Code Rate
4.
Data Rate
For detailed OID information, refer to the actual MIB file.
6.5 Telnet Interface
The modem provides a Telnet interface for two primary functions:
• Equipment M&C via the standard equipment Remote Control protocol
• Equipment M&C via Comtech Monitor and Control System (CMCS) application
Telnet connection is
allowed in both Serial
remote mode and Ethernet
remote mode. The Telnet
interface requires login at
the Administrator and
Read/Write User Access
Levels. An example of the
login process is shown
here:
Once logged into the
Telnet interface as the
Administrator, access the
standard remote control
interface defined in
Appendix D. REMOTE
CONTROL as shown
here:
To Next Page
Loading...
