CDM-570 Satellite Modem with Optional IP Module Revision 12
Base Modem Web Server Interface MN/CDM570L.IOM
7–13
Circuit ID
• Create a Circuit ID string of up to 24 alphanumeric characters. Click [Enter Circuit ID]
when done.
Unit
• Configure Test Mode, EDMAC Framing Mode, EDMAC Slave Address, and Stats
Sample Interval.
Click [Submit Unit Utilities] to save changes made to this section.
Clocks
• Configure Tx Clock Sources, Rx Buffer Size, Modem Frequency Reference, G.703 Clock
Extended Mode, and G.703 Clock Extend Interface.
Click [Submit Clocks] to save changes made to this section.
Submit Save and Load
• Use [Submit Save and Load] to save and/or load (recall) up to 10 configuration sets
numbered 0 through 9.
o To save a configuration set: Adjust all utilities parameters to suit, and then select 0
through 9 from the Save Location drop-down menu. Then, click [Submit Save and
Load] to store the configuration setting. The setting is then bookmarked with a time and
date stamp.
The default Save Location setting is Don’t Save.
o To load (recall) a configuration set: Select 0 through 9 from the Load Location drop-
down, and then click [Submit Save and Load] to load the configuration setting.
The default Load Location setting is Don’t Load.
To Next Page
Loading...
