Dionex As - Page 342

AS Autosampler Operator’s Manual
Index-4 Doc. 065051-03 1/08
Removing, 145
Drying well plates, 48
DSP does not acknowledge, 106
DSP not able to home XYZ motor arm, 115
Dual AS
Connections, 200
Duplicate column command, 224
E
Editing a method, 297
Editing a schedule, 274, 303
Editing screen fields, 13
Electrical specifications, 175
Enabling the Wait operation, 284
Enter button, 11
Entering values in screen fields, 273
Environmental specifications, 175
Error message log, 269
Error messages, 105
A DIRECT CONTROL command was
received while the sampler door is
open., 123
A failure has occurred during power up,
107
A NAK command was received from the
DSP, 112
An attempt was made to move a syringe
valve to an illegal position, 110
An attempt was made to move the syringe
to an illegal position, 110
An attempt was made to set an illegal
syringe speed, 110
An attempt was made to use the sample
prep syringe, 108
An illegal vial number was specified, 111
An injection was skipped because of a
problem in the autosampler, 123
Battery backed up RAM failed data
validation test, 113
Cannot run schedule. No DSP detected,
122
Cannot run schedule. No sample syringe
detected, 122
Cannot use sample syringe to aspirate from
specified source reservoir, 111
Current leak sensor voltage is outside of
legal calibration range, 119
Cycle time expired before INIT step was
completed, 115
DSP does not acknowledge, 106
DSP not able to home XYZ motor arm, 115
Format of calibration database has
changed, 116
Format of global database has changed.
Reinitializing to default values,
116
Format of method/schedule database has
changed, 116
Invalid leak sensor reading, 119
Leak detected in tray/syringe area, 118
Leak sensor needs recalibration, 119
Maximum number of steps reached, 105
Memory is full. Cannot save additional
method or schedule, 106
Method does not exist, 106
Method/Schedule database has been
corrupted, 117
Motion command to DSP was aborted, 119
Non-recoverable error. Both internal and
external inject valves are
connected, 122
Non-recoverable motion error occurred in
X axis, 114
Operation could not be completed because
vial tray is not installed, 111
Received invalid command from DSP, 113
Recoverable motion error occurred in X-
axis, 113, 116
Response from syringe contained data
errors, 109
Response from syringe was too long, 110
Sampler door opened, 118
Schedule error. Specified schedule does
not exist, 113