Dionex As - Page 343

Index
Doc. 065051-03 1/08 Index-5
Specified volume is larger than size of
sample syringe, 114
Syringe reports error, 121
Syringe reports fatal error, 121
Syringe size > 1 mL require the 8.5 mL
needle assy, 107 – 108
Syringe size less than 1 mL require the 1.2
mL needle assy, 107
Timed events step took so long to execute
that at least one subsequent step
was missed, 115
Timed out waiting for home position to be
found, 117
Timed out waiting for motion complete
command from DSP, 112
Timed out waiting for tray temperature to
stabilize, 122
Timeout occurred waiting for syringe serial
port txrdy, 109
Timeout occurred waiting for syringe to
complete an action, 108
Timeout occurred waiting for syringe to
respond to command, 109
Error sound
Turning on and off, 248
Evaporation of sample from well plates
(preventing), 48, 50
Example backpressure calculations, 98 – 99
Example method, 298
Example parameters
Partial-loop injection, 75
Partial-loop, limited-sample injection, 77
Simultaneous injection, 79
Example program
Concentrate mode, 85
Normal mode, 72
Sequential mode, 89
Simultaneous mode, 80
Extractions, 16
F
Facility requirements, 179
Factory-set default, 55
Filling a new syringe, 134
Firmware, 105
Fittings
Leaking, 125
Replacing, 127
Flow rates
For each prep syringe speed, 98
For each sample syringe speed, 97
Fluid schematics
Sample prep, 44
Sample syringe, 42
Sample syringe valve ports, 43
Sample valve ports, 43
Flush fluid, 187
Flush port, 19
Flush reservoir, 14
Flush syringe speed, 254
Flush/Prime screen, 257
Flushing the concentrator, 281, 290
Flushing the inject port, 41, 103, 257
Sequence of operations, 41
Flushing the needle, 239, 281, 287
Format of calibration database has changed,
116
Format of global database has changed, 116
Format of method/schedule database has
changed, 116
Front panel description, 8 – 12
Front panel operation
Accessing screens, 273
Aligning the sampling needle, 306
Calibrating the inject port volume, 311
Copying a method, 297
Copying a schedule, 303
Creating methods, 279 – 280
Creating schedules, 298 – 303
Defining sample prep steps, 281 – 290
Defining timed event steps, 294 – 296
Deleting a method, 297
Deleting a schedule, 303
Editing a method, 297
Editing a schedule, 303