ESAB Cutting Systems
CROSSBOW Page 107
4.25.2 【F2】System Parameters
In the SETUP menu, press the【F2】key to enter the SYSTEM parameter page:
Figure 86: SYSTEM Parameters
NOTE: These settings should not be changed by the operator!
SYSTEM parameters
NUMERATOR
Numerator of electronic axis scaling ratio, used to adjust positioning
accuracy.
DENOMINATOR
Denominator of electronic axis scaling ratio, used to adjust
positioning accuracy.
MACHINE ORIGIN Origin point for the Machine Coordinates
PROGRAM ORIGIN Origin point for the Program Coordinates
DRILL OFFSET Torch offset for drilling or scribing (not used on Crossbow)
BACKLASH Backlash of the machine's drive train (not used on Crossbow)
HOME DIRECTION Return direction when the machine is back to original point.
SOFT LIMIT+ Software limit in + direction
SOFT LIMIT- Software limit in - direction
To Next Page
Loading...
