ESAB Cutting Systems
CROSSBOW Page 17
1.5 Recommended Safety References
The following publications on welding and cutting safety are recommended for your review. These
publications have been prepared to prevent personnel injury and property damage, resulting from
unsafe practices. Although some sources are not related specifically to industrial cutting systems, the
principles of safety apply equally.
1.5.1 International
DIN EN ISO
• DIN EN ISO 3821 Hoses for welding, cutting and allied processes.
• DIN EN ISO 5172 Blowpipes for gas welding, heating, and cutting.
• DIN EN ISO 12100 Safety of Machinery - Basic concepts and general principles for design.
• DIN EN ISO 13849 Safety of Machinery - Safety related parts of control systems.
• DIN EN ISO 13857 Safety of Machinery - Safety distances to prevent hazard zones being
reached by upper and lower limbs.
• DIN EN ISO 14121-1 Safety of Machinery - Risk assessment.
DIN EN
• DIN EN 626-1 Safety of machines, reduction of risks to health
• DIN EN 730 Gas Welding Equipment - Safety devices.
• DIN EN 1037 Safety of Machinery - Prevention of unexpected start-up.
• DIN EN 1088 Interlocking devices associated with guards - Principles for design and selection.
• DIN EN 1127-1 Explosive prevention and protection - Part 1: Basic concepts and methodology.
• DIN EN 7287 Safety markings.
• DIN EN 60825 Radiation safety of laser products.
To Next Page
Loading...
