ESAB CROSSBOW - Page 171

ESAB Cutting Systems
CROSSBOW Page 171
• Screw and Nut should be replaced together.
• Ball bearing is pressed onto end of screw.
• Guide rods are pressed into upper and lower shaft holders. Disassembly is not recommended.
Figure 137: Torch Lift Assembly
Number Description
1 Bottom Cover
2 Bearing Spacer
3 Lower Shaft Holder
4 Guide Rods
5 Mounting Lug
6 Screw
7 Nut
8 Upper Shaft Holder
9 Flexible Coupling
10 Lift Gear-Motor
11 Ball Bearing (Hidden From View)
12 2 Pin Plug
13 Lower Limit Swtich
14 Upper Limit Switch
15 Diode Board
1
5
3
2
6
11
7
8
9
10
12
13
14
15
4