Broadcast
145
Fax
4
DTMF Method
The following needs to be pre-registered for the Address Number of the primary relay
station and the secondary relay station.
For information about Address Book registration, refer to "Address Book" (P.334).
Note • This method is only available for transmission between machines of this model.
The dialing format can be registered in Address Number to enable dialing using an Address
Number. For information about Address Book registration, refer to "Address Book" (P.334).
1 Select [Keyboard] to display the keyboard on the touch screen and enter the following
format.
2 Select [Next Recipient] to perform Multiple Relay Broadcast.
Password
A pre-registered two-digit number
Note • By default, no password is set. For setting a password, contact our Customer Support
Center. If a password has not been set, you do not need to enter one.
Relay Station ID
The last two digits of the initiating station Address Number registered at the primary
relay station.
Address Number
The Address Number for the secondary relay station registered at the primary relay
station.
F Code Method
When using the machine as the initiating station for performing remote Relay Broadcast
Send, confirm the F Code and the password (if necessary) for the primary relay station.
When using the machine as the primary relay station for performing remote Relay
Broadcast Send, inform the initiating station of the F Code (sub-address) and the
password (if necessary) and confirm the F Code for the secondary relay station.
When using the machine as the secondary relay station for performing remote Relay
Broadcast Send, inform the primary relay station of the F Code and the password (if
necessary).
Where Contents
Primary
relay
station
Assign the initiating station an Address Number from 001 to 500 and set Relay
Station Setup of the Address Number to [On].
Assign the secondary relay station an Address Number from 001 to 500.
z
As the relay station ID, assign the last two digits of the Address Number for
the primary relay station that is registered to the secondary relay station.
z
As the broadcast recipients, assign the Address Number for the relay
recipients that have been registered to the secondary relay station.
Secondary
relay
station
Assign the primary relay station the same Address Number as that of the
initiating station registered at the primary relay station, and set Relay Station
Setup of the Address Number to On.
Assign the relay recipient an Address Number from 001 to 500.
Address
Number
Relay
station ID
Password
The 1st relay station
telephone number
To Next Page