11 Setups
258
Setups
11
Base Tone
For a button that toggles (changes setting each time it is pressed), set the sound to be
made when in the home position. In the machine this sound is made when the
<Interrupt> button is released.
You can select the volume from [High], [Medium], and [Low]. To disable the sound,
select [Off].
Screen Defaults
Set the initial screen display when the power is turned on.
1 Select [Screen Defaults].
2 Select the item to be set or
changed, and select [Change
Settings].
3 Set the setting value.
4 Select [Save].
All Services
Set the layout of buttons that appear
in the [Menu] screen when the <All Services>
button on the control panel is pressed.
The layout of buttons shown on the [Button Layout on the Menu Screen] screen shows
the layout of buttons on the [Menu] screen.
Note • It is not possible to assign the same feature to more than one button.
1 Select [All Services], and select
[Change Settings].
2 Select the button in the position
where you want to display a
feature.
Note • Select [ ] to display the
previous screen and select [ ] to display the next screen.
3 Select [Features] or
[Supplementary Features].
4 Select the feature to be displayed.
Features
You can select a feature button. The feature buttons are the oval buttons in the [Menu]
screen.
If you select [Not Set], the selected button position will remain empty.
Supplementary Features
You can select an auxiliary feature button. The auxiliary features appear in the [Menu]
screen as rectangular buttons.
If you select [Not Set], the selected button position will remain empty.
To Next Page