Common Settings
257
Setups
11
Non-Copy Job Complete Tone
Select the sound to be made when a job other than copying completes.
You can select the volume from [High], [Medium], and [Low]. To disable the sound,
select [Off].
Fault Tone
Select the sound to be made when there is an error termination.
You can select the volume from [High], [Medium], and [Low]. To disable the sound,
select [Off].
Alert Tone
Select the sound to be made when a fault such as a paper jam occurs, and the fault is
left unattended to.
You can select the volume from [High], [Medium], and [Low]. To disable the sound,
select [Off].
Out of Paper Warning Tone
Select the sound to be made when there is no paper in the paper tray and the job is left
unattended to.
You can select the volume from [High], [Medium], and [Low]. To disable the sound,
select [Off].
Low Toner Alert Tone
Select the sound to be made when the drum toner cartridge is due to be replaced.
You can select the volume from [High], [Medium], and [Low]. To disable the sound,
select [Off].
Line Monitor Volume
You can relay the sound on the telephone circuit in the interval from dialing until the
connection is made through the speakers on the machine. This is convenient for using
FAX information services without using the telephone.
You can select the volume from [High], [Medium], and [Low]. To disable the sound,
select [Off].
Ringing Volume
Select the sound to be made when an incoming call arrives at the machine.
You can select the volume from [High], [Medium], and [Low]. To disable the sound,
select [Off].
Stored Programming Tone
Select the sound to be made while recording in job memory.
You can select the volume from [High], [Medium], and [Low].
Note • It is not possible to disable this sound.
Auto Clear Alert Tone
Select the sound to be made when the automatic clear feature is enabled and it is 5
seconds before automatically returning to the initial screen.
You can select the volume from [High], [Medium], and [Low]. To disable the sound,
select [Off].
To Next Page
Loading...
