2 Product Overview
38
Product Overview
2
About the Circuit Breaker
The machine is provided with a
circuit breaker.
In the event of a current leakage,
the breaker will automatically cut off
the power circuit to prevent any
leakage or fire from occurring.
The RESET button is normally in a
pressed-in state as shown in the
figure on the right. When the
machine is to be left unused for a
long period of time or is to be
moved, lightly press the TEST
button with the tip of a ball-pen or
other fine-tipped object to cancel
the pressed-in state of the RESET
button.
Once a month, check the breaker for correct operation. Also, make sure that it is
earthed. If not, the breaker cannot detect current leakage which can cause electric
shock.
If you notice any unusual conditions, contact our Customer Support Center.
Note • The RESET button automatically turns the power off when current leakage is detected.
Normally, do not operate this button.
• Before you cancel the pressed-in state of the RESET button, first make sure that the power
switch is off.
For information about inspection of circuit breaker operations, refer to "Power saving feature (Lower
Power mode/Sleep mode)" (P.24).
Power switch
RESET button
TEST button
To Next Page
Loading...
