15 Maintenance
422
Maintenance
15
2 Wipe the document glass with a
soft cloth moistened with water to
remove any dirt and then wipe it
with a soft, dry cloth.
Important • Do not use cleaning agents
other than water or neutral
detergent.
Note • If it is difficult to remove dirt,
try gently wiping with a soft
cloth moistened with a small
amount of neutral detergent.
Cleaning the Film and Document Feeder Glass
If the machine is equipped with a document feeder and the film and document feeder
glass are dirty, dirt may appear on copies and the machine may not properly detect
document sizes.
To ensure that clean copies are made, clean the machine about once a month.
Important • Do not use benzene, paint thinner, or other organic solvents. Doing so might damage paint
or coating on plastic parts.
• Cleaning the machine with an excessive amount of water may cause the machine to
malfunction or damage documents during copying.
1 Wipe the film section with a soft
cloth moistened with water to
remove any dirt and then wipe it
with a soft, dry cloth.
Important • Do not press with excessive
force because the film is
easily damaged.
• Do not use cleaning agents
other than water or neutral
detergent.
Note • If it is difficult to remove dirt, try gently wiping with a soft cloth moistened with a small amount
of neutral detergent.
2 Wipe the document feeder glass
with a soft cloth moistened with
water to remove any dirt and then
wipe it with a soft, dry cloth.
Important • Do not use cleaning agents
other than water or neutral
detergent.
Note • If it is difficult to remove dirt,
try gently wiping with a soft
cloth moistened with a small
amount of neutral detergent.
To Next Page