11 Setups
300
Setups
11
Preset %
You can select from twenty standard magnification ratios.
Variable %
You can set any magnification. Specify a value from 25% to 400%, in 1% increments.
Other Settings
These settings relate to the scanner feature specification.
1 Select [Other Settings].
2 Select the item to be set or
changed, and select [Change
Settings].
Note • Select [ ] to display the
previous screen and select
[ ] to display the next screen.
3 Select the setting value.
4 Select [Save].
Scan Service
Set whether or not to use the scanner feature.
Memory Full Procedure
While scanning an original, if there is insufficient hard disk space for the scanner, a
screen appears, asking how the partly stored data should be handled. Once a certain
time has elapsed with the confirmation screen displayed, the subsequent processing is
determined by these settings.
You can set the time until memory overflow handling is carried out. For more information, refer to
"Auto Job Release" (P.255).
Cancel Job
The stored data is discarded.
Run Job
The read-in data is treated as valid, and the part of the original read in is treated as a
complete file.
Maximum Stored Pages
Set the maximum number of stored pages of a scan original. You can set a number
from 1 to 999 pages.
Color Saturation
Set the saturation when scanning a full color original. When carrying out a scan, it is
automatically adjusted according to this setting value.
Auto Exposure Level
For a color scan, set the auto exposure level. This is valid when [Auto Exposure] is set
to [On].
The larger the value, the stronger the effect of removing background noise.
To Next Page