16 Problem Solving
488
Problem Solving
16
Stapler Faults
Below describes stapler troubles when the finisher (optional) is installed.
Follow the procedures on the following pages when copies are not stapled or when
staples are bent. Contact our Customer Support Center if the problem persists after you
have tried the following solutions.
If staples are stapled on the copies in the manner shown in the figures below, contact
our Customer Support Center.
Unstapled
Bent staple
One side of staple rising up Staple bent in reverse direction
Flattened staple Entire staple rising up
Staple rising up with
center pressed in
To Next Page
Loading...
