Copy Mode Settings
283
Setups
11
Annotation - Stamp Size
Set the size of stamp printed in the annotation.
You can select from three point sizes: 32 point, 48 point, and 64 point.
Annotation - Stamp Density
Set the translucency of the stamp printed in the annotation.
You can select from three translucency values: 0% (solid), 25%, and 50%. The 0%
value represents no translucency.
Note • With [0%], if the stamp is over text, the text may no longer be readable.
Stamp Position on Side 2
When an annotation stamp is specified for 2 sided copying, set where to place the
stamp printed on the reverse side.
Opposite to Side 1
Print in a position symmetrically opposite to the front side.
Same as Side 1
Print in the same position as the front side.
Date Position on Side 2
When an annotation date is specified for 2 sided copying, set where to place the date
printed on the reverse side.
Opposite to Side 1
Print in a position symmetrically opposite to the front side.
Same as Side 1
Print in the same position as the front side.
Page Number Position on Side 2
When an annotation page is specified for 2 sided copying, set where to place the page
printed on the reverse side.
Opposite to Side 1
Print in a position symmetrically opposite to the front side.
Same as Side 1
Print in the same position as the front side.
To Next Page