Error Code
461
Problem Solving
16
003-761
[Cause] The paper size of the tray selected for auto tray is
different from the paper size of the tray selected for Auto
Repeat.
[Remedy] Change the paper size for the tray, or change the [Paper
Type Priority] settings.
003-763
[Cause] An error occurred when reading the Gradation
Adjustment Chart.
[Remedy] Place the Adjustment Chart properly on the document
glass.
Refer to "Executing Auto Gradation Adjustment" (P.424).
003-780
[Cause] Failed to compress scanned document.
[Remedy] Reduce resolution or redution/enlargement ratio to
decrease the data size, or send in several pieces.
003-795
[Cause] When enlarging/reducing a scanned document to the
specified paper size, the redution/enlargement ratio
value exceeds the allowed range.
[Remedy] Take one of the following actions:
z
Manually enter a redution/enlargement ratio.
z
Change the paper size.
003-970
Refer to 003-976.
003-972
[Cause] The maximum storable document pages for each service
is exceeded.
[Remedy] Have your System Administrator check the [Maximum
Storable Page Number] settings.
003-973
[Cause] The document orientation and specified paper
orientation are different.
[Remedy] Start the job as is, or cancel the job and reconfigure.
003-976
[Cause] The document size exceeds the readable area, resulting
in an error.
[Remedy] Change the document size, or send in sections.
003-977
[Cause] For Bound Originals/Booklet Creation/Poster, when
resetting the document, the new document size is
different from the old size.
[Remedy Return to the document of the correct size, and restart.
003-980
[Cause] The specified staple position is incorrect.
[Remedy] Check and reconfigure the document orientation and
staple position, or cancel stapling.
003-981
[Cause] Stapling of mixed size documents is only possible when
the widths are the same.
[Remedy] Cancel stapling, or align the paper widths and
reconfigure.
005-275
005-280
005-283
005-284
005-285
005-286
[Cause] An error occurred in the document feeder.
[Remedy] Power-cycle the printer. Contact our Customer Support
Center.
Error Code
Category
Cause and Remedy
CPFSMO
To Next Page