Copying Procedure
47
Copy
3
1 Remove any clips and staples
before loading the document.
2 In the center of the document
feeder, set the document with the
side to be copied (top side if 2
sided document) facing upwards.
Note • The <Confirmation> indicator
lights when the document is
loaded correctly.
3 Adjust the movable document
guides to just touch the edge of the
document stack.
Document Glass
On the document glass, you can place a single sheet, or a book or other similar
document, up to 297 × 432 mm (A3, 11 × 17 inches).
On the document glass, only standard size documents can be detected automatically.
For non-standard size documents, enter a custom size in [Original Size].
For information about entering a custom size, refer to "Original Size (Specifying the Scan Size for the
Document)" (P.69).
1 Open the document cover.
2 Place the document face down,
and align it against the top left
corner of the document glass.
3 Close the document cover.
Note • When a standard size
document is placed on the
document glass, the size of
the document is displayed in
the message area.
To Next Page
Loading...
