Only for Japan/APAC:
Two foams are attached to the spare part of the HDD backplane to allow
the replacement in any mounting position.
When replacing the HDD backplane, detach the foam according to the
original mounting position.
Figure 91: 8x 2.5-inch HDD backplane with two foams
Preliminary steps
▶
"Locating the defective server" on page 47.
▶
If applicable, "Removing the front cover with lock" on page 49.
▶
"Shutting down the server" on page 50.
▶
"Disconnecting the power cord" on page 50.
▶
"Getting access to the component" on page 55.
▶
Release all HDD/SSD modules and pull them out a few centimeters, see
"Removing 2.5-inch HDD/SSD modules" on page 180.
The HDD/SSD modules need not to be removed. But if you want to
remove them nevertheless, check if all HDD/SSD modules are
uniquely identified so that you can reinsert them into their original
bays.
▶
Release all dummy modules and pull them out a few centimeters, see
"Removing a 2.5-inch HDD/SSD dummy module" on page
177.
▶
"Removing the fan cage" on page 76.
Hard disk drive (HDD) / solid state disk (SSD)
194 Upgrade and Maintenance Manual RX2540 M7
To Next Page
Loading...
