Installing the new 8x 2.5-inch HDD backplane
Figure 93: Installing the 8x 2.5-inch SAS HDD/SSD backplane
▶
Position the HDD backplane on the two hooks (see orange circles).
▶
Push the HDD backplane downward. Make sure that the HDD backplane fits
into the guide pins.
▶
Fasten the screw (see circle).
▶
If applicable, install the internal RAID riser module, see "Installing an
internal RAID riser module" on page
297.
▶
If applicable, install the SAS expander board holder, see "Installing the SAS
expander board holder" on page 205.
Figure 94: Connecting cables to the 8x 2.5-inch HDD backplane (example onboard SATA)
Hard disk drive (HDD) / solid state disk (SSD)
196 Upgrade and Maintenance Manual RX2540 M7
To Next Page
Loading...
