▶
Release all HDD/SSD modules and pull them out a few centimeters, see
"Removing a 2.5-inch HDD/SSD module" on page
181.
The HDD/SSD modules need not to be removed. But if you want to
remove them nevertheless, check if all HDD/SSD modules are
uniquely identified so that you can reinsert them into their original
bays.
▶
Release all dummy modules and pull them out a few centimeters, see
"Removing a 2.5-inch HDD/SSD dummy module" on page
178.
Removing the rear 2x 2.5-inch HDD backplane
▶
Disconnect all cables from the rear HDD backplane.
Figure 122: Removing the rear 2x 2.5-inch HDD backplane
▶
Loosen the screw (see circle).
▶
T
ake out the rear HDD backplane.
Hard disk drive (HDD) / solid state disk (SSD)
RX2540 M7 Upgrade and Maintenance Manual 237
To Next Page
Loading...
