Tools: Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Locating the defective server" on page
47.
▶
If applicable, "Removing the front cover with lock" on page 49.
▶
"Shutting down the server" on page 50.
▶
"Disconnecting the power cord" on page 50.
▶
"Getting access to the component" on page 55.
▶
"Removing the fan cage" on page 76.
▶
"Locating the defective component" on page 48.
Removing the defective riser card
▶
Remove the internal RAID riser module, see "Removing an internal RAID
riser module" on page 303.
▶
Remove the internal RAID riser card, see "Removing the defective riser
card" on page 308.
Figure 176: Removing the riser card
▶
Remove the two screws (see circles).
▶
Remove the riser card.
Expansion cards and backup units
308 Upgrade and Maintenance Manual RX2540 M7
To Next Page
Loading...
