▶
Proceed the steps in the recovery guidelines, see "iRMC S6 firmware
recovery guidelines after replacing an iRMC microSD card" on page
509
and "BIOS recovery guidelines after replacing an iRMC microSD card" on
page 509.
Concluding steps
▶
If applicable, install the expansion card in slot 5 and 6, see "Installing an
expansion card" on page 269.
▶
"Reassembling" on page 59.
▶
"Connecting the power cord" on page 65.
▶
Verify that the iRMC S6 recognizes the installed iRMC microSD card.
▶
Wait until the firmware restore is completed. BIOS or iRMC S6 firmware
restore feature is executed at the same time as the power cord is connected
after the iRMC microSD card replacement.
▶
If applicable, "Installing the front cover with lock" on page 71.
iRMC S6 firmware recovery guidelines after replacing an iRMC microSD
card
▶
After replacing the iRMC microSD card and starting up the iRMC S6
firmware, confirm that the iRMC microSD card backup completion message
in the iRMC S6 firmware is registered in the SEL.
<iRMC>
A backup of iRMC Firmware%1 has been successfully created
on SD card.
BIOS recovery guidelines after replacing an iRMC microSD card
Perform the following steps after replacing the iRMC microSD card on systems
with and without the ServerView related tools.
System board and components
RX2540 M7 Upgrade and Maintenance Manual 509
To Next Page
Loading...
