Fujitsu PRIMERGY TX1320 M4 - Removing a Hot-Plug PSU

TX1320 M4 Upgrade and Maintenance Manual 109
Power supply unit (PSU)
6.3.2.2 Removing a hot-plug PSU
Figure 34: Removing the PSU
Ê Push the handle of the PSU halfway upward in the direction of the arrow (1).
Ê Press in on the green locking latch (2).
Ê While keeping the green locking latch pressed, pull the PSU out of its bay
(3).
V CAUTION!
Never leave the bay for the hot-plug PSU empty for more than two
minutes during operation. Otherwise, excessive temperatures could
damage system components.