Fujitsu PRIMERGY TX1320 M4 - Installing a Dummy Cover; Concluding Steps

110 Upgrade and Maintenance Manual TX1320 M4
Power supply unit (PSU)
6.3.2.3 Installing a dummy cover
Figure 35: Installing the dummy cover
Ê Insert the dummy cover into the empty bay with the impressed arrow symbol
facing to the left (see circle).
Ê Push the dummy cover into its bay until it locks in place.
V CAUTION!
Always install dummy covers into unused bays to comply with
applicable EMC regulations and satisfy cooling requirements.
6.3.2.4 Concluding steps
Ê No steps needed.