Fujitsu PRIMERGY TX1320 M4 - Handling SFP+ Transceiver Modules; Installing SFP+ Transceiver Modules

TX1320 M4 Upgrade and Maintenance Manual 175
Expansion cards and backup units
9.3 Handling SFP+ transceiver modules
A network adapter is equipped with one or two SFP+ (small form-factor
pluggable) transceiver modules. SFP+ transceiver modules are hot-pluggable.
9.3.1 Installing SFP+ transceiver modules
Preparing the SFP+ transceiver module
Figure 81: Removing the protective cap
Ê Remove the SFP+ transceiver module from its protective packaging.
Ê Remove the protective cap from the new/additional SFP+ transceiver
module.
V CAUTION!
– Always keep the protective caps attached to the SFP+ transceiver
modules and fiber-optic cable connectors until you are ready to
make a connection.
– Keep the protective cap for future use.
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools: tool-less