TX1320 M4 Upgrade and Maintenance Manual 287
System board and components
14.4.2.3 Concluding steps
Ê "Reassembling" on page 57
Ê "Connecting the power cord" on page 60
Ê "Switching on the server" on page 63
14.4.3 Replacing the iRMC microSD card
14.4.3.1 Preliminary steps
Ê "Locating the defective server" on page 47
Ê "Shutting down the server" on page 49
Ê "Disconnecting the power cord" on page 50
Ê "Getting access to the component" on page 51
14.4.3.2 Replacing the iRMC microSD card
Ê Remove the defective iRMC microSD card, see section "Removing the
iRMC microSD card" on page 286.
V CAUTION!
The microSD card contains customer information. After replacing the
microSD card, hand the defective card over to the customer. If the
customer requests disposal of the defective microSD card, proceed
as follows:
Ê Using a pair of side-cutting pliers, cut the microSD card in half.
Ê Install the new iRMC microSD card, see section "Installing the iRMC
microSD card" on page 284.
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools: a pair of side-cutting pliers
To Next Page
Loading...
