Fujitsu PRIMERGY TX1320 M4 - Preliminary Steps; Removing the Defective 2.5-Inch HDD;SSD Module; Installing the New 2.5-Inch HDD;SSD Module; Concluding Steps

150 Upgrade and Maintenance Manual TX1320 M4
Hard disk drives (HDD) and solid state drives (SSD)
7.4.6.1 Preliminary steps
Ê "Locating the defective server" on page 47
Ê "Getting access to the component" on page 51
Ê "Locating the defective component" on page 48
7.4.6.2 Removing the defective 2.5-inch HDD/SSD module
Ê Remove the HDD/SSD module, see section "Removing a 2.5-inch
HDD/SSD module" on page 147.
Ê If applicable, remove the HDD/SSD from the installation frame, see section
"Handling HDDs or SSDs without installation frame" on page 131.
7.4.6.3 Installing the new 2.5-inch HDD/SSD module
Ê If applicable, install the HDD/SSD from the installation frame, see section
"Handling HDDs or SSDs without installation frame" on page 131.
Ê Install the HDD/SSD module, see section "Installing a 2.5-inch HDD/SSD
module" on page 145.
7.4.6.4 Concluding steps
Ê If the HDD/SSD is configured using a RAID controller with a RAID level
higher than "0", the rebuild will start automatically, see section "Performing
a RAID array rebuild" on page 87.
Ê "Reassembling" on page 57