Fujitsu PRIMERGY TX1320 M4 - Installing the Pcie Backplane; Connecting the Pcie Backplane to a PRAID Ep5 X0 I Controller; Concluding Steps

162 Upgrade and Maintenance Manual TX1320 M4
Hard disk drives (HDD) and solid state drives (SSD)
7.4.9.2 Installing the PCIe backplane
Ê Break out the plastic flap of the HDD fan module by hand from the HDD fan
module, see figure 74.
Ê Install the PCIe backplane, see section "Installing a HDD/PCIe backplane"
on page 154.
7.4.9.3 Connecting the PCIe backplane to a PRAID EP5x0i controller
Ê Connect the color-coded Oculink cable, see "Example: Connecting a PCIe
backplane (backplane 1)" on page 155.
I For more information about connecting SAS cables to the PRAID
EP5x0i, see section "Installing expansion cards" on page 180.
I For the cable plan, see chapter "Appendix B" on page 341.
7.4.9.4 Concluding steps
Ê Install all HDD fan modules removed before, see section "Installing the HDD
fan module" on page 167.
Ê "Installing a 2.5-inch HDD/SSD module" on page 145.
Ê "Reassembling" on page 57
Ê "Connecting the power cord" on page 60
Ê Update the system information of your server using the Chassis ID Prom
Tool, see section "Using the Chassis ID Prom Tool" on page 91. Select the
corresponding system name.
Ê "Switching on the server" on page 63
Ê "Performing a RAID array rebuild" on page 87