Fujitsu PRIMERGY TX1320 M4 - Acoustic Indicators

TX1320 M4 Upgrade and Maintenance Manual 335
Appendix A
15.2.4 Acoustic indicators
PEI Beep Codes
Pre-EFI Initialization (PEI) - memory Initialization (bootblock)
DXE Beep Codes
Driver Execution Environment (DXE) - main hardware Initialization (POST)
# of
Beep
Description Action
1 Memory not installed Ê Check if the memory module is installed.
Ê Check if the memory module is installed
correctly.
2 Recovery started Recovery procedure is initialized by jumper
settings on the system board and announced
with two beep.
This is only an information.
4 Recovery failed Ê Restart the recovery procedure again.
Ê If the same beep code sounds again,
replace the system board.
# of
Beep
Description Action
1 Invalid password Ê Check for the correct password and try
again.
Ensure that the caps lock key is
deactivated.
5 No Console Input
devices1 or Output
devices2 are found
Booting will continue.
1 Serial console redirection is considered a
console output device if enabled.
2 Serial console redirection is considered a
console input device if enabled.
This beep code is only an information.