144 Upgrade and Maintenance Manual TX1320 M4
Hard disk drives (HDD) and solid state drives (SSD)
7.4.4 Installing 2.5-inch HDD/SSD modules
7.4.4.1 Preliminary steps
Ê "Getting access to the component" on page 51
Ê Locate the correct drive bay, see section "2.5-inch HDD/SSD configurations"
on page 141.
7.4.4.2 Removing a 2.5-inch HDD/SSD dummy module
Figure 60: Removing a 2.5-inch HDD/SSD dummy module
Ê Press both tabs together (1) and pull the dummy module out of its bay (2).
V CAUTION!
Keep the dummy module for future use.
Always replace dummy modules into unused HDD/SSD bays to comply
with applicable EMC regulations and satisfy cooling requirements.
Customer Replaceable Unit
(CRU)
Hardware: 5 minutes
Tools: tool-less
To Next Page
Loading...
