Fujitsu PRIMERGY TX1320 M4 - Removing Expansion Cards; Preliminary Steps; Removing Oculink Cables

TX1320 M4 Upgrade and Maintenance Manual 187
Expansion cards and backup units
9.4.2 Removing expansion cards
9.4.2.1 Preliminary steps
Ê "Suspending BitLocker functionality" on page 67
Ê "Shutting down the server" on page 49
Ê "Disconnecting the power cord" on page 50
Ê If applicable, disconnect external cables from the expansion card.
Ê "Getting access to the component" on page 51
9.4.2.2 Removing Oculink cables
Figure 95: Oculink cables - release latch
Ê Press on the release latch (see arrow) to unlock the connector.
Ê Disconnect the Oculink cables.
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools:
Phillips PH2 / (+) No. 2 screw driver (only for removing the slot
bracket)