Fujitsu PRIMERGY TX1320 M4 - Replacing a 3.5-Inch Non Hot-Plug HDD; Preliminary Steps; Removing the Defective 3.5-Inch Non Hot-Plug HDD; Installing the New 3.5-Inch Non Hot-Plug HDD

140 Upgrade and Maintenance Manual TX1320 M4
Hard disk drives (HDD) and solid state drives (SSD)
7.3.4 Replacing a 3.5-inch non hot-plug HDD
7.3.4.1 Preliminary steps
Ê "Locating the defective server" on page 47
Ê "Locating the defective component" on page 48
Ê "Shutting down the server" on page 49
Ê "Getting access to the component" on page 51
7.3.4.2 Removing the defective 3.5-inch non hot-plug HDD
Ê Remove the non hot-plug HDD, see section "Removing a 3.5-inch non hot-
plug HDD" on page 138.
7.3.4.3 Installing the new 3.5-inch non hot-plug HDD
Ê Install the non hot-plug HDD, see section "Installing a 3.5-inch non hot-plug
HDD" on page 134.
7.3.4.4 Concluding steps
Ê "Reassembling" on page 57
Ê "Connecting the power cord" on page 60
Ê "Switching on the server" on page 63
Ê If the HDD/SSD is configured using a RAID controller with a RAID level
higher than "0", the rebuild will start automatically, see section "Performing
a RAID array rebuild" on page 87.
Upgrade and Repair Unit
(URU)
Hardware: 10 minutes
Tools: tool-less