TX1320 M4 Upgrade and Maintenance Manual 191
Expansion cards and backup units
9.4.3.3 Installing an expansion card
Ê If applicable, install the slot bracket, see section "Installing a slot bracket" on
page 173.
Ê Install the expansion card, see section "Installing the expansion card" on
page 181.
9.4.3.4 Concluding steps
Ê "Reassembling" on page 57
Ê If applicable, connect external cables to the expansion card.
Ê "Connecting the power cord" on page 60
Ê "Switching on the server" on page 63
Ê "Enabling replaced components in the BIOS" on page 82
Ê Inform the customer about changed WWN and MAC addresses, see
"Looking for MAC/WWN/GUID and SAS addresses" on page 88.
Ê After replacing a network controller in a server running Linux OS, "Updating
the NIC configuration file in a Linux and VMware environment" on page 86
Ê "Updating expansion card firmware" on page 73
Ê "Resuming BitLocker functionality" on page 87
Ê If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
I Configuration of network settings should be performed by the
customer. For more information, see section "Note on network
settings recovery" on page 190.
Ê If applicable, restore LAN teaming configurations, see "After
replacing/upgrading LAN controllers" on page 93.
To Next Page
Loading...
