EasyManua.ls Logo

Fujitsu PRIMERGY TX1320 M4 - CMOS Battery; Replacing the CMOS Battery; Preliminary Steps

Fujitsu PRIMERGY TX1320 M4
372 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TX1320 M4 Upgrade and Maintenance Manual 273
System board and components
14.2 CMOS battery
14.2.1 Replacing the CMOS battery
Safety notes
V CAUTION!
The CMOS battery must be replaced with an identical battery or with
a battery type recommended by the manufacturer.
Keep lithium batteries away from children.
Do not throw batteries into the trash can. Lithium batteries must be
disposed of in accordance with local regulations concerning special
waste.
For more information, see section "Environmental protection" on
page 44.
Ensure to insert the CMOS battery with the positive pole facing
up!
14.2.1.1 Preliminary steps
Ê "Locating the defective server" on page 47
Ê "Shutting down the server" on page 49
Ê "Disconnecting the power cord" on page 50
Ê "Getting access to the component" on page 51
Ê Remove the corresponding HDD fan: "Fans" on page 163
Ê If applicable, disconnect the Oculink cables from the PCIe backplane.
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools: tool-less; recommended: tooth pick

Table of Contents

Other manuals for Fujitsu PRIMERGY TX1320 M4

Related product manuals