Fujitsu PRIMERGY TX1320 M4 - Replacing the M.2 SSD; Concluding Steps; Software Configuration

TX1320 M4 Upgrade and Maintenance Manual 295
System board and components
14.5.3.2 Replacing the M.2 SSD
Ê Remove the defective M.2 SSD, see section "Removing the M.2 SSD" on
page 292.
Ê Install the new M.2 SSD, see section "Installing an M.2 SSD" on page 288.
14.5.3.3 Concluding steps
Ê If applicable, connect the SATA cable of the ODD from the system board.
Ê If applicable, connect the Oculink cables to the PCIe backplane.
Ê If applicable, "Installing expansion cards" on page 180.
Ê If applicable, install the HDD fan module 2.5-inch HDD variant, see section
"Replacing the HDD fan module" on page 164.
Ê "Reassembling" on page 57
Ê "Connecting the power cord" on page 60
Ê "Switching on the server" on page 63
14.5.3.4 Software configuration
I To install the ESXi to the M.2 SSD, see "Software configuration" on
page 291.