Fujitsu PRIMERGY TX1320 M4 - Installing the FJBU; Concluding Steps

118 Upgrade and Maintenance Manual TX1320 M4
Power supply unit (PSU)
6.4.1.3 Installing the FJBU
Figure 41: Installing the FJBU
Ê Push the FJBU into its bay (see arrow) as far as it will go until the locking
latch snaps in place.
V CAUTION!
Ensure that the FJBU properly engages in its bay and is locked in
position in order to prevent it from sliding out of the chassis during
transportation.
6.4.1.4 Concluding steps
Ê No steps needed.
I To execute auto shutdown after power fail, you should install the FJBU
management software. How to install and configure the FJBU
management software, see the FJBU user guide.